A2 D-BUS Adapter modulo per utilizzare una ricevente tradizionale, oppure per estendere le porte di uscita.
Per l'utilizzo, fare riferimento al manuale della A2, sezione D-BUS Adapter.
The DJI D-BUS adapter module can provide an eight-way input or output for the A2 Multirotor Flight Controller. A traditional receiver can be used through D-BUS adapter module, or it can be used to extend the output ports on the A2. Please refer to the A2 user manual D-BUS adapter section for more specific details of the functionality offered. When using a traditional D-BUS receiver with the A2, the DJI D-BUS adapter is required.
D-BUS Adapter Setup:
Put the switch to the "I" stop, and power on the system. The Led should be on red; otherwise keep the switch at the "I" stop and then power cycle the system.
At the "I" stop, the D-BUS Adapter is converting the PWM signal from traditional receiver to S-BUS signal.
The A2 D-BUS adapter comes supplied with 8 female to female servo cables needed to connect the A2 D Bus adapter.
For additional information please visit the DJI A2 product page.