Parallel Charge Board for JST-XH - HXT 4 mm Bullet
Codice: BIZ-BCA094 Prezzo: €24.00
Parallel Charge Board for JST-XH - HXT 4 mm Bullet.
This product is designed to work with a balance charger to charge - balance up to 6 batteries (including lithium , lipo, life, lion) at the same time. It is simple, reliable, safe and cheap.
Instruction:
- 1. Connect the balance lead to the balance socket of your charger and the parallel charging board.
- 2. Connect the power cable of the parallel charging board to the output port of your charger.
- 3. Connect batteries to the parallel charging board always connect the balance leads first, then connect the power cable. Set the charging voltage - current on your charger by using the following method.
- V: charge voltage
- V: the charge voltage of each battery
- n: the qty of battery
Note:
- 1. Please make sure to use the same cell number of batteries.
- 2. If the maximum output current of your balance charger is smaller than the I value please set your charger to its maximum current output.
- 3. The max current of this parallel charging board is 30 A.
- 1. Housing: XH FM 2-6S
- 2. Wire: 12 AWG L=300 mm
- 3. Balance Wire: JST XH 6S M to M L=200 mm
Trova video
Discuti sul forum
Cerca nel blog
