CellDIAG X6 Pro - 1-6S cellmeter capacity display with back light.
The CellDIAG is designed to measure the battery pack voltage for 2-6 cells (CellDIAG 6X)/ 2-4 cells (CellDIAG 4X) Li-Po/Li-Ion/Li-Fe batteries with balance charging port.
Features:
- Small, light and ultra-portable with only 5 mm thickness including the LCD screen.
- High resolution dot-matrix LCD screen has a display capability of cell count, individual cell voltage, and total pack voltage simultaneously, up to 6 cell (for CellDIAG6X) / 4 cell (for CellDIAG4X).
- High voltage resolution with +/-0.01V (10 mv).
- High precision, not less than +/-2% accuracy.
- Able to direct observe the battery pack balancing condition efficiently.
- Able to record the minimum voltage during the flight.
- Voltage measurement trimming.
- Reverse connection protection
Remarks and attentions:
Due to the battery pack loading drop, to avoid the voltage checking difference/ error, make sure the battery pack is disconnected from the load, and observe the reading 30 seconds later the disconnection.
Data display refresh rate may drops in low temperature environment. This is normal because of the LCD panel characteristics.
Although it is a device with ultra low power consumption, make sure disconnect the battery after use to void over discharge/ damage to the battery.
Specification:
- Working Temperature Range: -20 to 50 degrees
- Weight: 21 g
- Dimension: 33x69x11 mm
Trova video
Discuti sul forum
Cerca nel blog
