GP750:
- Utilizes Silicon Micro Machines (SMM) sensor with excellent stability to dramatically reduce in-flight tail drifts.
- Utilizes AHTCS (Active Helicopter Tail Control System) to compensate any drift caused by wind direction and force, as well as unintended yaw induced by helicopter itself during flight maneuvers.
- Tailor made specifically for use with high speed digital rudder servos. This gyro festures high sensitivity and minimal reaction time, fully utilizing the potential of modern high speed digital rudder servos.
- Suitable for all sizes of helicopters, from micro indoor to large 90 size glow helicopters.
- Metallic dampening plate built into bottom gyro casing, dramatically increasing anti-vibration and anti-interference abilities.
- Features 1520 us pulse wide and 760 us narrow pulse wide frame rate.
- Digital/Analog servo switchable.
- Reverse switch.
- Rudder servo travel limit adjustment (ATV).
- Mode switch for large/mini helicopter.
- Delay adjustment.
- Gyro locking mode and gain can be adjusted remotely from the transmitter.
1.Mini/Micro heli mode, suitable for T-Rex 250/450 ("Status" Red); Medium/large heli mode, suitable for T-Rex 500/600/700 ("Status" Green)
2.There are 3 kinds of 760 us narrow pulse wide servos on the market, including Futaba S9251, S9256, BLS251.
DS650:
- Ultra-speed servo for instant tail control reaction(0.048 sec/60 deg).
- 12 Bits 4096 signal resolution for smooth movements.
- Ultra Performance Coreless Motor with fast reaction and low current.
- Hardened high strength superalloy gears that increase the lifetime.
- Aluminum alloy mid case construction for instantaneous heat dissipation, maintaining servo's high efficiency.
- Supports digital - analog control signal.
- Powerful and precise servo, suitable for T-Rex 600/700 rudder use.
Specification:
GP750 Ratings:
- Operating Voltage: DC 4.5-7 V
- Current Consumption: minor 80 mA at 4.8 V
- Angular Detection Speed: 500 degrees/sec
- Operating Humidity: 0-65 degrees
- RoHS certification.
- Operating Humidity: 0-95 percent
- Size: 26x25x11 mm
- Weight: 14 g
DS650 Ratings:
- Stall torque (4.8 V): 4.0 kg.cm
- Stall torque (6.0 V): 5.0 kg.cm
- Motion speed (4.8 V): 0.058 sec/60
- Motion speed (6.0 V): 0.048 sec/60
- Rating voltage: DC 4.8-6 V
- Temperature range:-20 +60 C
- Dimension: 40.3x20.1x36 mm
- Weight: 56 g
- 1520 us standard band
Accessories:
- Double sided tape x 2
- Servo rudder piece x 3
- Set screw x 1
- Rubber damper x 4
- Brass grommet x 4
- Tapping screw for servo x 4