G.T power tester can be powered by lipo battery through the balance charging wire adaptor or DC power supply. It is both convenient and flexible.
The rolling menu toolbar makes the operation clear and easy.
The function setting is easy and practical which covers most parameters that end users need.
The device is equipped with servo and receiver wires, which makes the measurement operation a lot easier.
The device is equipped with clear and high contrast LCD Monitor to show individual parameter and menu selection. Which assures the user will see the testing information accurately and completely.
Bigger buttons are used over the smaller ones, which proves good feedback and reduces misoperations.
Functions:
- LN Mode
This function is used to test the linearity and vibration of servo.
(This can also be used to test the linearity and vibration point of ESC)
- ED Mode
The function is used to test the endurance of servo.
- FP Mode
This function is used to test the servo's ability to neutral itself.
(If equipped on the plane, you can find out the theoretic mid-point of servo exactly)
- DB Mode
The function is used to test the dead band of servo.
(It can also be used to calculate the resolution of servo)
The test can also be used to choose the servo based on differential timing.
(This great for models like CCPM which need 3 servos for it's rotor head)
- SP Mode
This function is used to perform speed test for servo, and it allows you to choose the most competent servo based on all the parameters that is performed in the test (E.g. Reaction Time and Differential Timing).
- WP Mode
The function is used to test the ageing and life of the servo.
There are some certain reparative functions for some aquiver servos.
- PW Mode
This function is used to test the output pulse of connector and test whether there is any problem on the signal unstable of the quiver of servo.
Trova video
Discuti sul forum
Cerca nel blog
